Goblet door installation method 10 small steps to accomplish ea



  • The glass door is a special door in your life. It is a compelling door. The glass used in the current glass door is principally divided into tempered cup and ordinary float glass, and generally has any thickness of 12 mm (mm). Manufactured from glass, it is stable with tempered glass. So it is extremely safe. And now the glass doors are made of clear glass, and there are very good lighting efficiency. Then, Xiaobian will cover the knowledge of this Laminated Glass online door, and I hope that it'll be very helpful to every person.

    Glass door installation system

    1. Positioning of the particular pay-off: The glass door coupled with the fixed glass and also the movable glass door leaf is uniformly positioned for setting.

    2. Limiting groove along at the top of the increasing frame: The width in the limiting slot should be higher than 2-4mm for the tumbler thickness and 10-20mm for the groove depth. When setting up, firstly pull out both the metal decorative board edges from the drawn line, and then press the side line to install the limit slot on the top of the doorway frame.

    3. Install the wooden bottom of the metal veneer: first fix the square wood for the ground, then stick the metal veneer towards the wood with the universal glue. The square wood could be directly nailed to this pre-embedded wooden brick, or in the expansion bolt. The approach to connection is fixed.

    4. Install the vertical entry frame: connect the center distinct the bullet to the actual door frame, then make use of the plywood to determine the contour and position of that door frame column, and finally wrap the metal decorating surface.

    5. Install that glass: use a goblet suction cup machine to be able to suck the thick tumbler, then hold the suction pot to lift the wide glass plate by 2-3 persons and move it to the installation position.

    6. Preset glass: Two small square wooden strips for the bottom and side with the wooden block are placed at the center door, the square wood strip is around 4mm away from the particular glass plate surface, and the universal glue is painted for the square wooden strip. The facing metal is stuck within the square strip.

    7. Treatment glass seal: In the gap between the top part limit groove and the underside bracket, and the gap in between the thick glass as well as the frame column, the goblet seal is injected.

    8. Docking between glass: When the fixed component to the glass door should be spliced by the oversize, the seam should have a width of 2-3mm, as well as edge of the glass ought to be chamfered.

    9. Installation connected with moving glass door leaf: Ahead of the door leaf is fitted, the grounding spring as well as positioning pin on the top end surface of the door frame needs to be positioned and installed. The 2 main must be coaxial. Check the vertical collection during installation to ensure the center of the ground spring shaft and the positioning pin. The lines are within the same line.

    10. Installation the glass door leaf upper and lower door clamps: Install top of the and lower metal door clips about the upper and lower ends from the glass door and measure the height on the door.

    Today's glass doors have grown common in our world, and there are many different kinds of glass doors, for example decorative glass doors, protection glass doors, energy-saving cup doors, coated glass gates, induction glass doors, and so on. But no matter which form of glass door has top notch noise reduction performance, windproof effectiveness, dustproof performance and etc. Therefore, it is traditional in many industries, for example hotels, hotels, banks, business office buildings, hospitals, shops, etc.,and the most popular is the pedal-sensing a glass door.